Undo 2 screws holding the hot idle gubbins, disconnect the vacuum pipes and remove -īottom HIC vacuum pipe sits on the very bottom of the carb. Undo bolt holding acceleration pump arm and slide arm out of the pumps plunger (left hand side in photo). Remove carb (practice throwing at neighbor's dog). Take a note of how the gaskets and channeled spacer plate sit, leave them on the manifold. Undo the four bolts holding carb to manifold (could be from the top depending on model). Every bit you see or remove give it a good squirt with CarbMedic and clean it, it will be basically the same for a carb with an automatic choke.įirst disconnect choke, accelerator, fuel line and fuel solenoid wire. Note: This is for a manual choke carb and is not a full strip down, just enough to get to the important bits and to give them a clean.
0 Comments
Leave a Reply. |